A spray system is added on the basis of the steam-type electric iron, which has multiple functions of temperature adjustment, steam injection and spraying. The steam injection system is the same as that of a steam-type electric iron. When the temperature of the soleplate is higher than 100℃, press the spray button and the water control lever opens the drip nozzle. The water drops into the vaporization chamber and vaporizes, and sprays from the spray holes on the soleplate. Out. The spray device and the steam generating device are independent of each other. Press the spray button by hand, the piston in the spray valve is pressed down, the round steel ball of the valve closes the hole at the bottom of the valve tightly, and the water in the valve is sprayed out of the spray nozzle through the guide hole of the piston rod as a mist; release your hand After that, the spray button is automatically reset. Due to the action of the valve, the water in the water storage chamber pushes the round steel ball at the bottom of the valve open, and enters the valve through the bottom hole.
It is constructed by adding a steam injection device to the ordinary electric iron, which has the dual function of temperature regulation and steam injection. There are several steam spray holes on the soleplate of this electric iron, and a sealed water storage tank is arranged on the soleplate and heating element. The water inlet of the water storage tank is set at the front end of the handle, the steam outlet pipe and the water storage tank Connected, there is a valve on the steam outlet pipe, and the button on the handle controls the steam injection or stops the steam injection. When the electric heating element is energized to heat the bottom plate, it also heats the water in the water tank, and the water boils and vaporizes to produce steam. The water vapor is ejected from the steam spray hole on the bottom plate through the pipe, so that the clothes to be ironed are moistened by the water vapor. The rear half of the water reservoir is separated from the bottom plate. When steam spraying is not required, the iron only needs to be erected, and the water in the water reservoir will stop heating and save heat.