The working environment of the embroidery machine includes the physical environment and the electrical environment. Generally, the physical environment can meet the conditions in a normal workshop, not too dry or too humid, the temperature is 0-50 degrees Celsius, and the relative temperature is 30%~70%. Good ventilation and high electrical requirements require stable voltage. It is best to install a transformer. The working voltage is generally 380V or 220V. Some foreign countries use 110V. The working power is generally 1.5KW to 2KW, and the single-head machine is generally 500W. The current generated at the moment of opening and shutting down is much larger than that during stable operation. Frequent switching will cause excessive heating or system overload, which will reduce the service life of the embroidery machine. This should also be paid attention to.
(1) When all the pins are in the high position, the dial cannot be turned by hand;
(2) Do not jog when the pin is in the high position, otherwise it is easy to get stuck;
(3) Make preparations before driving the lever, wear the bottom thread, choose the pattern to be embroidered, choose the working method that matches the pattern and the appropriate embroidery parameters;
(4) Check whether all the pins are put down before driving the lever. If not, put all the pins down manually, and then pull the lever to drive, otherwise it is easy to cause damage to the machine or leaking flowers;
(5) When embroidering sequins, the switch of the sequin device should be set to the upper position, otherwise the sequin device will not automatically rise and fall;
(6) The air pressure of the sequin device should be appropriate, too small to be unable to lift automatically, and too large to break the sequin device. After adjusting the air pressure, do not adjust it casually;
(7) Every time a new three-in-one combination pattern is made, the frame check should be done first after setting the embroidering point, so as to prevent the frame from overshooting when the left and right machine heads are switched, and the sequin device or machine head will be damaged;
(8) When taping embroidery and zigzag embroidery mending embroidery, you should first loosen the upper thread on all the machine heads and the taping (or zigzag core thread) on the reel, and at the same time raise all the pins to the high position. Put the manipulator to the non-working state, and then reverse the car, otherwise the fabric may be torn. After finishing the mending and embroidering, first arrange the tapes (or serrated core wires) on all the reels, put down the pins, put the manipulator in the work position, and then pull the rod to drive;
(9) When embroidering a piece of embroidery, after pressing the piece of embroidery function key, you should loosen all the cloth clamps before moving the embroidery frame, otherwise the fabric will be easily torn. After changing the frame, first clamp the fabric in the front, press the jog button to let the needles and pins leave the fabric, and then clamp the fabric clamp at the back, so that the fabric clamped is relatively flat;
(10) After each pattern is embroidered, all the cloth clips must be placed on the two corners of the front of the table when removing the cloth clips. They cannot be placed on the wire rack or behind the table to prevent the cloth from being clipped on the fabric. Or fall into the gap of the platen connecting plate, causing damage to the cloth surface or the machine;